TM 5-3805-254-20-1
FUEL GAGE SENDING UNIT
This task covers:
a.
REMOVAL (page 2-516)
c.
TESTING (page 2-518)
b.
INSPECTION (page 2-517)
d.
INSTALLATION (page 2-518)
INITIAL SETUP
Tools
Personnel Required
Multimeter, AN/URM-105C
One
Screwdriver, flat-tip, 3/16-inch
Wrench, box-end, 3/8-inch
Equipment Condition
Materials/Parts
Disconnect battery cables (page 2-424).
Gasket, fuel gage sending unit
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Diesel fuel burns easily. Do not smoke or allow flames nearby. DIS-connect batteries when
working on fuel system. Failure to observe these precautions could cause serious injury or death
to personnel.
1.
Top of front fuel
Three screws (2)
a.
Using 3/16-inch flat-tip screwdriver,
tank (1)
and cover (3)
unscrew and take out three screws.
b.
Take off cover.
2.
Fuel gage sending
Nut (5) and brown
Using 3/8-inch box-end wrench, unscrew
unit (4)
wire (6)
and take off.
3.
Three screws (7) and
Using 3/16-inch flat-tip screwdriver, un-
red wire (8)
screw and take out.
4.
Top of front fuel
Fuel gage sending
a.
Take out.
tank (1)
unit (4) and
b.
Get rid of gasket.
gasket (9)
2-516
