TM 5-3805-254-20-2BATTERY NEGATIVE CABLEThis task covers:a.Removal (page 2-824)d.Inspection/Replacement (page 2-827)b.Disassembly (page 2-826)e.Assembly (page 2-827)c.Cleaning (page 2-826)f.Installation (page 2-828)INITIAL SETUPToolsTools - ContinuedApron, rubberWrench, open-end, 9/16-inch (two required)Brush, wireCleaner, battery terminalMaterials/PartsExtension, 6-inch, 1/2-inch driveGloves, safetyGrease, GAA (item 10, appendix C)Goggles, safetyRags, wiping (item 15, appendix C)Handle, ratchet, 1/2-inch driveSoda, bicarbonate (item 17, appendix C)Knife, pocketPuller, battery terminalPersonnel RequiredSocket, 3/4-inch, 1/2-inch driveWrench, box-end, 3/4-inchOneWrench, open-end, 1/2-inch (tworequired)ACTIONLOCATIONITEMREMARKSWARNINGRubber apron, safety gloves, and safety goggles must be worn when working withbatteries. Failure to observe this precaution could cause serious injury to personnel.Do not smoke, use open flame, or allow sparks near batteries. Mixture of oxygen andhydrogen gases released from batteries is highly flammable and can explode causinginjury to personnel.REMOVAL1.Two hooks (1)Two latches (2)Lift up and take off.2.BatteryCover (4)Lift up and take out.compartment (3)3.Left frameCable (6), screwUsing 3/4-inch 1/2-inch drive socket, 6-rail (5)(7), and nut (8)inch extension, ratchet handle and 3/4-inchbox-end wrench, unscrew and take off.2-824
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business