TM 5-3805-254-202
AUTOMATIC OVERRIDE MODULE - CONTINUED
INITIAL SETUP - CONTINUED
Personnel Required
Equipment Condition
One
Battery ground cable disconnected
(page 2-424).
Right side cab door opened (page 2-424).
Instrument panel pad removed (page 2-424).
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
For more information on how to tag parts, go to General Maintenance Instructions (page 2-424).
1. Automatic override
Four nuts (2) and
a. Tag wires.
module (1)
four wire termi-
b. Using 11132-inch, box-end wrench,
nals (3)
unscrew and take off four nuts.
c. Take off four wire terminals.
2. Support (4)
Two screws (5),
a. Using number three cross-tip screw-
automatic override
driver, unscrew and take out two
module (1), and two
screws.
flat washers (6)
b. Take off automatic override module.
c. Take off two flat washers.
INSTALLATION
3.
Two screws (5),
a. Put flat washers in place.
automatic override
b. Put automatic override module in place.
module (1), and two
c. Screw in and tighten using number three
flat washers (6)
cross-tip screwdriver.
4. Automatic override
Four nuts (2)
a. Put wire terminals in place.
module (1)
and four wire
b. Screw on and tighten using 11132-inch
terminals (3)
box-end wrench.
c. Take off tags.
d. Get rid of tags.
2-878
