TM 53805254202
TRANSMISSION SHIFT CONTROL STAND - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
CLEANING
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective safety goggles and gloves
and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes and do not
breathe vapors. Do not use near open flame or excessive heat. The flashpoint for type #1
drycleaning solvent is 1000F (380C) and for type #2 is 138°F (590C). If you become dizzy while
using cleaning solvent, get fresh air immediately, and get medical aid. If contact with eyes is
made, flush your eyes with water and get medical aid immediately.
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-424).
3.
Transmission shift
a.
Clean rust or corrosion using wire
control stand (1)
brush.
b.
Clean using drycleaning solvent and
wiping rag.
c.
To touchup or repaint, refer to
TM 43-0139.
4.
All metal parts
Clean using drycleaning solvent and wiping
rag.
INSPECTIONIREPLACEMENT
NOTE
Replace all damaged or defective parts.
For more information on how to inspect parts, go to General Maintenance Instructions
(page 2-424).
5.
Transmission shift
a.
Look for excessive rust or corrosion.
control stand (1)
b.
Look for severe dents or distortion which
could effect installation or operation of
transmission shift control.
6.
All threaded parts
Look for damaged threads or rounded
heads.
2-918
