TM 5-3805254-20-2
TRANSMISSION SHIFT CABLE - CONTINUED
INITIAL SETUP
Tools
Materials/Parts - Continued
Gloves, safety
Lockwasher, U-bolt (two required)
Goggles, safety
Rags, wiping (item 15, appendix C)
Pliers, roundnose, 8inch
Solvent, drycleaning (item 19, appendix C)
Pliers, slip-joint, 12-inch
Wrench, box-end, 3/8-inch
Personnel Required
Wrench, open-end, 7116-inch
Two
Materials/Parts
Equipment Condition
Cotter pin, shift cable swivel
(if required)
Transmission shift control removed
Grommet (Shift cable)
(page 2-909).
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Safety goggles must be worn when working under truck to prevent eye injury.
NOTE
Equipment condition leaves transmission shift cable disconnected and ready to be pulled out of truck.
Assistance will be needed to remove transmission shift cable from under truck.
1.
Cab floor (1)
Transmission shift
Pull out.
cable (2)
2.
Grommet (3)
a.
Take out.
b.
Get rid of.
DISASSEMBLY
3.
Transmission shift
Shift cable swivel
a.
Using 12-inch slip-joint pliers and 7/16-
cable (2)
(4) and jamnut (5)
inch open-end wrench, loosen.
b.
Screw off shift cable swivel.
c.
Screw off jamnut.
2-920
