TM 5-3805-254-20-2
REAR BRAKES
This task covers:
a.
Removal (page 2-956)
b.
Cleaning (page 2-961)
c.
Inspection/Replacement
(page 2-963)
INITIAL SETUP
Tools
Brush, cleaning
Brush, wire
Gage, depth, tire tread
Gloves, safety
Goggles, safety
Hammer, ball-peen, 2-pound
Hammer, plastic-face
Handle, ratchet, 1/2-inch drive
Mask, filter
Pliers, brake repair
Pliers, retaining ring
Pliers, roundnose, 8-inch
Press, anchor pin
Screwdriver, flat-tip, 1/8-inch
Socket, 3/4-inch, 112-inch drive
Socket, 15/16-inch, 1/2-inch drive
Vacuum, industrial-type
Wrench, box-end, 9/16-inch
Wrench, box-end, 15116-inch
Wrench, open-end, 15/16-inch
Materials/Parts
Compound, antiseizing (item 4,
appendix C)
Cotter pin, clevis
Grease, GAA (item 10, appendix C)
d.
Installation (page 2-965)
e.
Adjustment (page 2-973)
Materials/Parts - Continued
Locknut, airbrake chamber (two required)
Locknut, brake spider (eight required)
Lockwasher, brake spider (eight required)
Lockwasher, camshaft bracket (four required)
Packing, anchor pin (four required)
Packing, brake camshaft
Rags, wiping (item 15, appendix C)
Ring, slack adjuster (one required)
Ring, anchor pin (four required)
Screw, dust shield (six required)
Solvent, drycleaning (item 19, appendix C)
Personnel Required
Two
Equipment Condition
Rear hub and brakedrum assembly removed
(page 2-1188).
References
TM 5-3805-254-10 (Operator’s Manual)
2-955
