TM 5-3805-254-20-2
REAR BRAKES - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Parts of the service brake assembly will be coated with asbestos dust
Breathing
this
dust
may
be
hazardous to your health Use a filter mask approved for use against asbestos dust Never use compressed air
or dry brush to clean these assemblies Dust shall be removed using an industrial-type vacuum cleaner with a
high-efficiency filter system.
NOTE
Steps given are typical for right and left front rear and rear rear brakes.
1
Brake assembly (1)
Using industrial-type vacuum, clean off
asbestos dust.
2
Slack adjuster (2)
Adjusting screw
Using 9/16-inch box-end wrench, push in
(3) and locking
on locking sleeve and turn until brake cam-
sleeve (4)
shaft S-head (5) is horizontal and slack
adjuster is loose.
3
Upper dust
Three screws(7)
a
Using 9/16-inch box-end wrench, un-
shield (6)
screw and take out.
b
Get rid of.
4
Upper dust
Take off.
shield (6)
2-956
