TM 5-3805-254-20-2
PARKING BRAKE LINES - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
CAUTION
Antiseizing tape must be used on all pipe threads to provide a good seal and to prevent threaded parts
from seizing.
NOTE
For more information on how to use antiseizing tape, go to General Maintenance Instructions (page 2-
424).
16.
Cab rear
Cab floor through
Wrap pipe threads with antiseizing tape.
floor (1)
connector 90-degree
elbow (2)
17.
Cab floor through
Line nut (3) and
a.
Screw on and tighten using 5/8-inch
connector 90-degree
air line (4)
open-end wrench.
elbow (2)
b.
Route air line as shown.
18.
Left side rear
Air line (6) and
a.
Push air line through hole.
cab wall (5)
left lower rear
b.
Put left lower rear molding in position.
molding (7)
19.
Left lower rear
Eight screws (8)
Screw in and tighten using number two
molding (7)
and eight flat
cross-tip screwdriver.
washers (9)
20.
Left side
Left scuff plate
a.
Put left scuff plate in position.
cab floor (10)
(11) and fourteen
b.
Screw in and tighten using number two
screws (12)cross-tip screwdriver.
2-1030
