TM 5-3805-254-20-2 AIR COMPRESSOR TO AIR DRYER HOSE AND LINES - CONTINUED ACTION LOCATION ITEM REMARKS REMOVAL WARNING Safety goggles must be worn when working under truck to prevent eye injury. NOTE Air line is in three sections.  Tag sections from front to rear of truck as section 1, section 2, and section 3. For more information on how to tag parts, go to General Maintenance Instructions (page 2-424). 1. Air compressor (1) Air line (2) Tag. 2. Air line (2) Line nut (3) Using 1-inch open-end wrench, unscrew and take off. 3. Three clamps (4) Screw (5), lock- a. Using 7/16-inch box-end and 7/16-inch washer (6), and open-end wrenches, unscrew and take nut (7) out. b. Get rid of lockwasher. c. Take clamps off air line (2). 4. Air line (2) and Line nut (9) and a. Using 1-inch and 15/16-inch open-end airhose (8) line nut (10) wrenches, unscrew and take off. b. Take out air line (2). 5. Airhose (8) Tag. 6. Airhose (8) and Line nut (12) and a. Using 1-inch and 15116-inch open-end air line (11) line nut (13) wrenches, unscrew and take off. b. Take out airhose (8). 7. Air line (11) Tag. NOTE Step 9 is typical for two clamp assemblies. 8. Air line (11) Screw (14), lock- a. Using 7/16-inch box-end and 7/16-inch washer (15), nut open-end wrenches, unscrew and take (16), clamp (17), out. and clamp (18) b. Get rid of lockwasher. c. Take clamp (17) off air line. 9. Air dryer (19) and Line nut (21) and a. Using 15/16-inch open-end wrench, 90-degree elbow (20) air line (11) unscrew and take off. b. Take out air line. 2-1036