TM 5-3805-254-20-2
DATA AND INSTRUCTION PLATES
This task covers:
a
Removal (page 2-1350)
c
Installation (page 2-1353)
b
Cleaning (page 2-1352)
INITIAL SETUP
Tools
Materials/Parts - Continued
Bit, drill, 1/8-inch
Rags, wiping (item 15, appendix C)
Bit, drill, 5/32-inch
Screw, self-tapping (as required)
Drill, portable, electric, 1/4-inch
Goggles, safety Personnel Required
Knife, putty
Screwdriver, cross-tip, number one
One
Screwdriver, cross-tip, number two
Equipment Condition
Materials/Parts
Right and left cab doors opened (page 2-424).
Data and instruction plates (as required)
Naptha (item 11, appendix C)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
Step 1 is typical for the removal of all data and instruction plates attached with adhesive.
1. Automatic override
Four nuts (2) and
a. Tag wires.
1
Inside driver’s
Instruction
Using putty knife, scrape off.
door (1)
plate (2)
WARNING
Safety goggles must be worn when using a portable electric drillFlying metal particles can cause eye
injury.
NOTE
Steps 2 and 3 are typical for the removal of all data and instruction plates attached with rivets.
2-1350
