TM 5-3805-254-20-2
TURN SIGNAL SWITCH
This task covers:
a.
Removal (page 2-744)
b.
Installation (page 2-746)
INITIAL SETUP
Tools
Personnel Required
Pliers, diagonal-cutting, 6-inch
One
Screwdriver, cross-tip, number one
Wrench, open-end, 9/16-inch (two
Equipment Condition
required)
Battery ground cable disconnected
Materials/Parts
(page 2-424).
Left side cab door opened (page 2-424).
Lockwasher, bracket (three required)
Strap, tiedown, self-locking (item 20,
appendix C)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1.
Steering column (1)
Connector (2)
Pull apart.
2.
Instrument panel
Electrical tiedown
a.
Using 6-inch diagonal-cutting pliers,
support (3) and
strap (5)
cut.
wire harness (4)
b.
Get rid of.
3.
Instrument panel
Jamnut (8)
Using two 9/16-inch open-end wrenches,
(6) and screw (7)
unscrew and take out.
4.
Instrument panel (6)
Screw (7), flat
Using two 9/16-inch open-end wrenches,
washer (9), clamp
unscrew and take out.
(10), and nut (11)
5.
Steering column (1)
Turn signal switch
a.
Using number one cross-tip screw-
(12), bracket (13),
driver, unscrew and take out.
three screws (14),
b.
Get rid of lockwashers.
and three lock-
washers (15)
2-744
