TM 5-3805-254-34
9-5.
REAR-REAR DIFFERENTIAL MAINTENANCE (Con’t).
b.
DIFFERENTIAL REMOVAL AND DISASSEMBLY
1.
Mount differential carrier (2) in vise with soft jaw
2.
Cut lockwire (7) securing bolts (8) in bearing ca
(9). Discard lockwire.
3.
Mark bearing cap (9) and legs of differential
carries (2) to ensure proper assembly and
installation.
4.
Remove two bolts (8) and bearing cap (9).
5.
Repeat steps 2 through 4 for other bearing cap
(9
6.
Lift differential (11) out of differential carrier (2).
7.
Remove two bearing races (10) from legs
differential carrier (2).
WARNING
Tightly hold no-spin differential together to contain spring pressure as differential case of Is
removed. Failure to follow this warning may result In Injury to personnel or damage to differential
case assembly components.
NOTE
Bolt, two washers, and nut used In step 8 should be from shop stock and are used to old no-spin
differential assembly together when differential case half is removed.
8.
Install bolt (12), two washers (13), and nut (15) through center of no-spin differential assembly (14). Tighten nut
fingertight.
TA703972
9-41
