TM 5-3805-254-34
12-5. STEERING ARMS REPLACEMENT (Con’t)
3.
Remove screw (8) and lockwasher (7) from nut
(6). Discard lockwasher.
4.
Remove nut (6).
NOTE
Note position of steering arm on steering
gear output shaft for assembly.
5.
Using puller, remove steering arm (4) from
steering gear output shaft (5) and drag link (1).
b.
INSTALLATION
NOTE
•
Perform the following steps to Install steering arm to steering gear and drag link at either left or right side
of vehicle.
•
To provide proper alinement of steering arm to steering gear output shaft, an arrow Is stamped on
steering arm and an arrow or dot is stamped on steering gear output shaft. These marks must be alined
when steering arm is Installed on steering gear output shaft.
1. Install steering arm (4) on steering gear output shaft (5) and front end of drag link (1).
2. Install nut (6). Torque nut to approximately 450 Ib.ft. (610 Nom) and until screw (8) can be installed through nut
and into threaded hole of steering gear output shaft (5).
3. Install new lockwasher (7) and screw (8) to nut (6).
4. Install front end of drag link (1) to steering arm (4) with slotted nut (3) and new cotter pin (2).
TA704036
12-26
