TM 5-3805-254-3412-6. STEERING COLUMN MAINTENANCEThis Task Covers:a.Removalb.Disassemblyc.Cleaning and InspectionInitial Setup:Equipment Conditions:•Hood opened (see TM 5-3805-254-10).•Steering wheel removed (see paragraph 12-9).•Turn signal switch removed (see TM 5-3805-254-20).Tools/Test Equipment:•General mechanic's tool kit•Field automotive shop setReferences:•LO 5-3805-254-12a.REMOVAL1. Replace nut (1) loosely on end of drive shaft (2).2. Disconnect lead and roller (3) from connector(4).3. Remove two nuts (5), screws (8), four washers(6), and cover (9) from jacket tube (7).NOTENote position of pin In steering column bracketand hole In jacket tube for assembly.4. Remove two nuts (10), screws (13), fourwashers (11), and steering column cap (12) fromsteering column bracket (14).d.Assemblye.InstallationMaterials/Parts:•Detergent (Item 6, Appendix B)•Dry cleaning solvent (Item 23, Appendix B)•One locknut•One seal•One seal washer•Two repair kits•Four cotter pinsGeneral Safety Instructions:•Dry cleaning solvent is flammable and mustnot be used near open flame. Use only in awell-ventilated area.TA70403812-28
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business