TM 5-3805-254-34
12-8. STEERING KNUCKLE MAINTENANCE
4.
Remove hydraulic jack.
5.
Coat surface of new pin (18) with grease.
NOTE
Ensure that pin is positioned so that
flat area will contact tapered key
when key is Installed in end of axle.
6.
Press pin (18) into steering knuckle (3) and axle
(17).
7.
Install new plug (15) and new snaprlng (14) in
bottom of steering knuckle (3).
8.
Install new cap (12) and new gasket (13) to top
of steering knuckle (3) with new lockwasher (11)
and new screw (10).
9.
Coat surface of tapered key (16) with grease and
press Into end of axle (17) until tightly seated.
TA704065
12-56