TM 5-3805-25434
13-3
REAR SPRINGS REPLACEMENT (Con’t).
b.
CLEANING AND INSPECTION
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective
goggles and gloves, and use only In a well-ventilated area. Avoid contact with skin,
eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open flame or
excessive heat. The solvent's flash point is 100°F-138°F (38°C-590C). If you become
dizzy while using cleaning solvent, immediately get fresh air and medical help. If
solvent contacts eyes, Immediately wash your eyes and get medical aid.
1.
Clean metal parts with dry cleaning solvent.
2.
Inspect metal parts for cracks, breaks, wear, corrosion, and other damage. Replace if damaged.
3.
Inspect rear spring leafs for cracks, breaks, and distortion. Replace rear springs if damaged.
c.
INSTALLATION
NOTE
Perform steps 1 through 3 only if spring bracket was removed. Perform these
steps for each spring bracket to be replaced.
1.
Position plate (21) on frame (20) and install spacer bar (31) and axle stop (30) with four screws (29) and nuts (22).
2.
Install skid plate (23), two spacer bars (25), and bracket (1) on frame (20) with six screws (28) and nuts (24).
3. Install screw (26) and nut (27) on bracket (1).
13-16
