TM 5-3805-264-13&P
0065
REMOVAL
WARNING
DO NOT disconnect hydraulic lines while engine is running. Engine must be shut down and
dump body fully lowered or supported on body props before lines are disconnected.
Escaping hydraulic fluid under pressure can penetrate the skin. Hydraulic oil is slippery and
may cause falls. A suitable container should be used to catch any draining hydraulic fluid.
Ensure that all spills are cleaned up immediately and disposed of in accordance with local
procedures. Failure to comply may result in personnel injury or death.
CAUTION
Hoses and ports in hydraulic components should be plugged to prevent contamination of
hydraulic system (WP 0072). Failure to comply may result in damage to equipment.
NOTE
Hoses should be tagged before removal (WP 0072).
1.
At lower end of hydraulic cylinder (Figure 1, Item 2), disconnect hose assemblies (Figure 1, Item 7) from
elbows (Figure 1, Item 6). Remove elbows.
WARNING
Use extreme care when handling heavy parts. Lifting cables, chains, hooks, and slings
must be in good condition and of suitable capacity. Keep clear of parts supported only by
lifting device. Failure to comply may result in personnel injury, death, and/or damage to
equipment.
2.
Install lifting sling through loop in hydraulic cylinder (Figure 1, Item 2) and attach lifting sling to lifting device.
3.
Remove locknut (Figure 1, Item 9), screw (Figure 1, Item 11), and pivot pin (Figure 1, Item 10) from cylinder
support frame (Figure 1, Item 8) and hydraulic cylinder (Figure 1, Item 2). Discard locknut.
4.
While holding hydraulic cylinder (Figure 1, Item 2) securely, remove six locknuts (Figure 1, Item 3), screws
(Figure 1, Item 5), and left and right mounting brackets (Figure 1, Items 4 and 12) from dump body
(Figure 1, Item 1). Discard locknuts.
5.
Remove left and right mounting brackets (Figure 1, Items 4 and 12) from hydraulic cylinder
(Figure 1, Item 2).
0065-2
03/15/2011Rel(1.10)root(maintwp)wpno(M1005026413)