TM 5-3805-264-14&P
4-67.
CARGO COVER SUPPORT FRAME AND ROLL-UP BAR REPLACEMENT (Con’t).
4.
Loosen set screw (13) and remove sprocket (20) with sprocket alinement key (12) from roll-up bar (14).
5.
Remove three nuts (16), lockwashers (17), and screws (18) from left mounting bracket (15) and dump
body. Discard lockwashers.
6.
Loosen set screw (19) at each end of roll-up bar (14). Remove left mounting bracket (15) and roll-up bar.
Slide bracket from roll-up bar.
b.
CLEANING AND INSPECTION
Clean and inspect all components in accordance with Chapter 4, Section III, General Maintenance
Instructions.
1.
Install left mounting bracket (15) on roll-up bar (14). Position roll-up bar on dump body and through right
mounting bracket (21).
2.
Install three screws (18) new lockwashers (17), and nuts (16) to left mounting bracket (15) and dump
body.
3.
Loosen set screw (19) at each end of roll-up bar (14) and center bar between left and right mounting brack-
ets (15 and 21). Tighten set screws.
4.
Install sprocket alinement key (12) and sprocket (20) on roll-up bar (14). Tighten set screw (13).
4-109
