TM 5-3805-264-14&P
4-67.
CARGO COVER SUPPORT FRAME AND ROLL-UP BAR REPLACEMENT.
This task covers:
a. Removal
b. Cleaning and Inspection
c. Installation
Initial Setup:
Equipment Conditions:
l Cargo cover removed (paragraph 4-64).
l Cargo cover chain removed (paragraph 4-66).
Tools/Test Equipment:
l General mechanic’s tool kit (Item 8, Appendix I)
Materials/Parts:
l One locknut
l One spring pin
l Five lockwashers
NOTE
Left and right side components of cargo cover support frame are removed and
installed the same way; left side is illustrated.
a.
REMOVAL
1 .
2.
3.
Remove spring pin (11) from shaft (6) on spring assembly (7). Remove swing arm (5) from shaft. Discard
spring pin.
Remove locknut (4) and screw (2) and separate swing arm (5) and connecting arm (3). Discard locknut.
Remove two nuts (10), lockwashers (9), and screws (8) from spring assembly (7). Remove spring assem-
bly from dump body and from welded shaft support bar and tube (1). Discard lockwashers.
4-108
