TM 5-3805-264-14&P
5-4.
HYDRAULIC PUMP REPLACEMENT (Con’t).
hon.5
Clean and inspect components in accordance with Chapter 4, Section III, General Maintenance lnstruc-
Use extreme caution when handling heavy parts. Lifting device is required when
parts weigh over 50 lb (23 kg) for a single person lift. Failure to follow this warning
may cause injury to personnel or damage to equipment.
NOTE
1.
2.
Use antiseize tape on all pipe threads (paragraph 4-22).
Install hydraulic pump (5) to PTO (21) with four screws (1), new lockwashers (2), and nuts (3).
Install support bracket (7) to transmission housing (14) with two screws (10). Torque screws to 70-80 lb.-ft.
(95-108 N•m).
3.
Install washer (8) and nut (9) to stud (6) of hydraulic pump (5).
4.
Install elbow (16) to control valve (4).
5.
Connect hose (15) to elbow (16).
5-12
