TM 5-3805-264-14&P
5-4.
HYDRAULIC PUMP REPLACEMENT (Con't).
NOTE
1.
2.
3.
4.
5.
6.
7.
8.
Remove two screws (10) and support bracket (7) from transmission housing (14)
9.
Hoses should be tagged before removal (paragraph 4-17).
A suitable container should be used to catch any draining hydraulic fluid.
Ensure that all spills are cleaned up.
Loosen clamp (11) and disconnect suction hose (12) from adapter (13).
Remove adapter (13) from hydraulic pump (5).
Disconnect hose (19) from adapter (20). Disconnect hose (18) from adapter (17).
Remove adapters (17 and 20) from control valve (4).
Disconnect hose (15) from elbow (16).
Remove elbow (16) from control valve (4).
Remove nut (9) and washer (8) from stud (6) of hydraulic pump (5).
Use extreme caution when handling heavy parts. Lifting device is required when
parts weigh over 50 lb (23 kg) for a single person lift. Failure to follow this warning
may cause injury to personnel or damage to equipment.
Remove four nuts (3), lockwashers (2), screws (1), and hydraulic pump (5) from PTO (21). Discard lock-
washers.
5-11
