TM 5-3805-274-13&P
0027
NOTE
Right and left side mud flaps are removed and installed the same
way, only one mud flap is shown.
REMOVAL
1. Remove four locknuts (Figure 1, Item 1), washers (Figure 1, Item 2), bolts (Figure 1, Item 4), washers
(Figure 1, Item 3), and plate (Figure 1, Item 14) with mud flap (Figure 1, Item 8) from mounting bracket
(Figure 1, Item 17). Discard locknuts (Figure 1, Item 1).
2. Remove four locknuts (Figure 1, Item 16), washers (Figure 1, Item 15), bolts (Figure 1, Item 7), washers
(Figure 1, Item 6), backup bar (Figure 1, Item 5), and mud flap (Figure 1, Item 8) from plate
(Figure 1, Item 14). Discard locknuts (Figure 1, Item 16).
3. Remove four locknuts (Figure 1, Item 13), washers (Figure 1, Item 12), bolts (Figure 1, Item 9), washers
(Figure 1, Item 10), and two backup bars (Figure 1, Item 11) from mud flap (Figure 1, Item 8). Discard
locknuts (Figure 1, Item 13).
4. Remove blind rivet (Figure 1, Item 19) and reflector (Figure 1, Item 18) from plate (Figure 1, Item 14).
Discard blind rivet (Figure 1, Item 19).
END OF TASK
INSTALLATION
1. Install reflector (Figure 1, Item 18) on plate (Figure 1, Item 14) with new blind rivet (Figure 1, Item 19).
2. Install two backup bars (Figure 1, Item 11) on bottom of mud flap (Figure 1, Item 8) with four bolts
(Figure 1, Item 9), washers (Figure 1, Item 10), washers (Figure 1, Item 12), and new locknuts
(Figure 1, Item 13).
3. Install mud flap (Figure 1, Item 8) on plate (Figure 1, Item 14) with four bolts (Figure 1, Item 7),
washers (Figure 1, Item 6), backup bar (Figure 1, Item 5), washers (Figure 1, Item 15), and new locknuts
(Figure 1, Item 16).
4. Install plate (Figure 1, Item 14) with mud flap (Figure 1, Item 8) to mounting bracket (Figure 1, Item 17)
with four bolts (Figure 1, Item 4), washers (Figure 1, Item 3), washers (Figure 1, Item 2), and new
locknuts (Figure 1, Item 1).
0027-2