TM 5-3805-274-13&P
0026
REMOVAL
1. Start engine and engage PTO (TM 9-2320-273-10). Raise dump body bed, raise safety strut to locked
position, lower dump body bed, and shut down engine.
2. Cut wire (Figure 1, Item 1) at splice conductor (Figure 1, Item 2). Discard splice conductor
(Figure 1, Item 2).
3. Remove wire (Figure 1, Item 1) from grommet (Figure 1, Item 3) and crossmember.
4. Remove two blind rivets (Figure 1, Item 7), retainer clips (Figure 1, Item 6), conduit (Figure 1, Item 4),
and wire (Figure 1, Item 5) from frame rail.
5. Cut wires (Figure 1, Items 8, 12, and 14) at splice conductor (Figure 1, Item 2). Discard splice conductor
(Figure 1, Item 2). If necessary, remove blind rivet (Figure 1, Item 7), lockwashers (Figure 1, Item 10),
and washer (Figure 1 Item 11). Discard rivet (Figure 1, Item 7) and lockwashers (Figure 1, Item 10).
6. Cut wires (Figure 1, Items 1 and 5) at splice conductor (Figure 1, Item 2). Discard splice conductor
(Figure 1, Item 2).
7. Remove wires (Figure 1, Items 1, 5, 8, 12, and 14), terminal lug (Figure 1, Item 9), and conduit
(Figure 1, Items 4 and 13) from dump body bed (Figure 1, Item 15) and frame rail.
END OF TASK
INSTALLATION
1. Instal terminal lug (Figure 1, Item 9), wires (Figure 1, Items 1, 5, 8, 12, and 14), and conduit
(Figure 1, Items 4 and 13) on dump body bed (Figure 1, Item 15) and frame rail.
2. Connect new splice conductor (Figure 1, Item 2) to wires (Figure 1, Items 1 and 5).
3. Connect new splice conductor (Figure 1, Item 2) to wires (Figure 1, Items 8, 12, and 14). If removed,
install terminal lug (Figure 1, Item 9), new blind rivet (Figure 1, Item 7), new
lockwasher (Figure 1, Item 10), and washer (Figure 1, Item 11).
4. Install conduit (Figure 1, Item 4) and wire (Figure 1, Item 5) on frame rail with two retainer clips
(Figure 1, Item 6) and new blind rivets (Figure 1, Item 7).
5. Install grommet (Figure 1, Item 3) and wire (Figure 1, Item 1) on crossmember.
6. Install new splice conductor (Figure 1, Item 2) on wire (Figure 1, Item 1).
7. Start engine and engage PTO (TM 9-2320-273-10). Raise dump body bed (Figure 1, Item 15), lower
safety strut to stowed position, lower dump body bed, and shut down engine.
0026-2
