TRUCK SERVICE MANUAL
BODIES AND CABS
WINDSHIELD
WASHER
AND
WIPER
MOTOR
To Install:
CONTROLS
Position vent assembly and secure with new rivets.
To remove the wiper motor or windshield
CAB AIR INTAKE
washer controls:
To remove the cab air intake located on right side
1. Remove six screws securing access panel
cowl, take out the seven screws securing it to the cowl
to cab header panel, Fig. 38.
panel.
Fig. 38
Fig. 41 Cab Mounting (Exploded View)
2. Remove windshield wiper control knob.
Legend for Fig. 41
3. Remove hex nuts securing wiper motor con trol
Key Description
and/or windshield washer control to access
panel.
1.
BOLT, Hex Head
4. Disconnect air lines from wiper control.
2.
WASHER, Flat
5. Disconnect electrical wiring or air line and fluid
3.
SPRING, Mounting
hose from washer control, whichever is
4.
INSULATOR, Rear Mounting Rebound
applicable.
5.
RETAINER, Rebound Pad
6. Remove wiper motor control and/or washer
6.
BRACKET, Rear Upper Cab
control.
7.
INSULATOR, Mounting
8.
BRACKET, Rear Cab
To Install:
9.
RETAINER, Rebound Pad
10.
NUT, Hex
Reverse the foregoing procedure for installation of wiper
11.
BRACKET, Front Cab Mounting
motor or windshield washer controls.
12.
BRACKET, Left Front Body Mounting
COWL VENTILATOR
13.
BUSHING, Front Mounting
14.
BRACKET, Right Front Body Mounting
To Remove:
15.
BOLT, Hex Head
16.
SPACER, Lower Body Mounting
1. Drill out rivets securing vent assembly cab.
17.
SPACER, Upper Body Mounting
2. Remove vent assembly.
18.
SPACER, Cab Mounting
95
