MOTOR TRUCK SERVICE MANUAL
BODIES AND CABS
Well-seasoned wood should be used for filler block
ation, regular lubricant intervals based on type of service
construction.
and road conditions should be established. Thorough
lubrication at definite intervals will add greatly to the
LUBRICATION
service life of the vehicle and will reduce the overall
operating expense of the vehicle.
There are a number of points on the cab where
periodic application of lubricant will increase the service
Following are points on the cab to be lubricated and
life of the parts as well as eliminate objectionable
the type of lubricant to use. Wipe off all lubrication points
squeaking.
before applying new lubricant. When lubricating the
points, apply lubricant sparingly so as not to allow excess
New vehicles are properly lubricated at the factory
lubricant to get on the operator's clothing.
and before they are delivered to the customer. After the
vehicle is placed in oper-
LUBRICANT POINT
LUBRICANT
Door Dovetail........................................................ Lubricate with Stick Lubricant
Door Hinge Pins ................................................... Light Engine Oil
Door Lock Assembly and Remote Control ........... Lubriplate 110 or Equivalent
Door Latch Striker Plate ....................................... Lubricate with Stick Lubricant
Door Lock Cylinder ............................................... Lock Oil
Door Window Regulator, Gear Teeth,
Arm Pin and Slide .......................................... Lubriplate 110 or Equivalent
Seat Adjuster ........................................................ Lubriplate 110 or Equivalent
Hood Pivot Bar ..................................................... Lithium 12- Hydroxy Stearate
EP Grease
Butterfly Type Hood Hinge, .................................. Light Engine Oil
Fender and Splash Panel Assembly
To Remove:
1. Raise hood.
2. Remove four nuts securing wiring harness clips to
FRONT END SHEET METAL
splash panel.
Fender
3. Disconnect headlight and directional light wiring.
To Remove:
4. Disconnect horn wire.
1. Disconnect headlight and directional light
5. Remove fender grommet.
wiring.
6. Pull headlight wiring through grommet opening.
2. Remove fourteen bolts, lockwashers and
nuts securing fender to chassis.
7. Remove bolts securing fender to front and rear
support braces.
3. Lift off fender.
8. Lift off fender and splash panel as an assembly.
To Install:
To Install:
To install fender, reverse the foregoing
Reverse the foregoing procedure for fender
procedure.
and splash panel installation.
100
