TRUCK SERVICE MANUAL
ENGINE
STEAM CLEAN ENGINE EXTERIOR
Prior to steam cleaning remove all electrical components
electrical controls, as used.
NOTE: Cover all openings with water proof tape.
In addition to actual time-saving affected by engine
cleaning, inspections can be made more quickly and
accurately during disassembly if surfaces are clean.
A heavy-duty steam cleaner is preferred; however, any
model for general use is satisfactory.
ENGINE DISASSEMBLY
Prior to mounting engine on engine stand remove the
following:
Fig. 0-3, (N100119). Removing water transfer tube (FFC
Series)
Rock Shield
Oil Gauge and Bracket
Water Filter
Mechanical Controls, Water, Air, Fuel Connections,
Filters
and Lines
Turbocharger and Connections
Oil Spray Nozzles
Water Transfer Tube (FFC Series)
Oil Cooler and Connections
Auxiliary Oil Cooler (if used)
Water Pump, Idler and Fan Hub (FFC Series), See
Fig's. 0-3 and 0-4
Fig. 0-4, (N100120). Removing fan hub assembly (FFC
Series)
MOUNT ENGINE ON ENGINE STAND
Replace water header cover plates with mounting
adapter plates. Secure ST-805 Engine Stand Adapter to
ST-548 Engine Rebuild Stand. Position engine to stand,
With engine mounted securely to roll-over stand, remove
the following:
Fan Hub, Belts And Brackets
Using ST-893 or ST-845 Fan Hub Wrench, remove fan
hub shaft locknut, adjusting screw, and belts, lift shaft
and hub from bracket. Remove fan hub bracket and
water pump or cavity cover.
322