TM 5-3805-254-20-1
ACCELERATOR CONTROL ROD - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
20. Accelerator control
Two locknuts (2)
Loosen and turn locknuts to end of threads.
rod (1)
NOTE
With correct alinement, machine bolt will slide in throttle lever easily.
21. Throttle lever (3)
Accelerator control
a.
Hold ball joint assembly from turning.
rod (1), ball joint
b.
Turn accelerator control rod until ma-
assembly (4), and
chine bolt aligns with hole in throttle
machine bolt (5)
lever.
22. Throttle lever (3)
Flat washer (6), new
a.
Put threaded end of machine bolt in
and machine
lockwasher (7), and
throttle lever.
bolt (5)
nut (8)
b.
Screw on and tighten using two 1/2-inch
open-end wrenches.
23. Accelerator control
Two locknuts (2)
a.
Hold accelerator control rod from
rod (1)
turning.
b.
Turn until locknuts touch ball joint
assemblies.
c.
Tighten using two 9/16-inch open-end
wrenches.
NOTE
For more information on cotter pins, go to General Maintenance Instructions (page
2-424).
24. Throttle lever (3)
Modulator cable (9),
a.
Put on modulator cable and flat washer.
and machine bolt (5)
flat washer (10),
b.
Put in new cotter pin and bend back legs
and new cotter
using 6-inch diagonal-cutting pliers.
pin (11)
2-556
