TM 5-3805-254-20-1
ACCELERATOR CONTROL ROD - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT
27. Fuel pump bracket
Spring (3)
Using 6-inch slip-joint pliers, take off.
(1) and accelerator
control rod (2)
28. Bracket (4) and
Spring (6)
Using 6-inch slip-joint pliers, take off.
modulator cable (5)
NOTE
For more information on cotter pins, go to General Maintenance Instructions (page
2-424).
29. Throttle lever (7)
Modulator cable (5),
a.
Using 6-inch diagonal-cutting pliers,
and machine bolt (8)
cotter pin (9), and
close legs of cotter pin and pull out.
flat washer (10)
b.
Take off.
30. Accelerator control
Two locknuts (11)
Using two 9/16-inch open-end wrenches,
rod (2)
loosen.
31. Throttle lever (7)
Accelerator control
Using two 1/2-inch open-end wrenches,
rod (2), machine
unscrew and take off.
bolt (8), nut (12),
Do not take machine bolt out of
lockwasher (13), and
accelerator control rod.
flat washer (14)
NOTE
Throttle lever and accelerator control rod must aline to reach maximum engine
rpm.
32. Throttle lever (7)
Accelerator control
a.
Push throttle lever toward rear of truck
rod (2), machine
and hold in position.
bolt (8), and ball
b.
Hold ball joint assembly from turning.
joint assembly (15)
c.
Turn accelerator control rod until ma-
chine bolt aligns with hole in throttle
lever.
2-558
