TM 5-3805-254-20-1
ACCELERATOR CONTROL LEVER
This task covers:
a.
Removal (page 2-562)
c.
Inspection (page 2-565)
b.
Cleaning (page 2-564)
d.
Installation (page 2-566)
INITIAL SETUP:
Tools Materials/Parts - Continued
Extension, 12-inch, 1/2-inch drive
Lockwasher, lever assembly
Gloves, safety
Solvent, drycleaning (item 19, appendix C)
Goggles, safety
Gun, blow, air
Personnel Required
Handle, ratchet, 1/2-inch drive
Hose, air, assembly
Equipment Condition
Pliers, diagonal-cutting, 6-inch
Pliers, slip-joint, 6-inch
Right and left side hood panels opened
Socket, 9/16-inch, 1/2-inch drive
(page 2-424).
Wrench, box-end, 9/16-inch
Air Cleaner element removed (page 2-452).
Wrench, open-end, 7/16-inch
Left side cab door opened (page 2-424).
Wrench, open-end, 1/2-inch
Engine cover removed (page 2-1270).
Battery cables disconnected (page 2-424).
Materials/Parts
References
Cotter pin, swivel
Lockwasher accelerator control rod
TM 9-247 (Authorized Cleaning Methods)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1.
Fuel pump bracket
Spring (3)
Using 6-inch slip-joint pliers, take off.
(1) and accelerator
control rod (2)
NOTE
For more information on cotter pins, go to General Maintenance Instructions (page
2-424).
2.
Lever assembly (4)
Cotter pin (5),
a.
Using 6-inch diagonal-cutting pliers,
flat washer (6),
close ends of cotter pin and pull out.
and swivel (7)
b.
Take off.
c.
Get rid of cotter pin.
2-562
