TM 5-3805-254-20-1
ACCELERATOR CONTROL ROD - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT - CONTINUED
34. Accelerator control
Two locknuts (2)
a.
Hold accelerator control rod from
rod (1)
and two ball joint
moving.
assemblies (3)
b.
turn until locknuts touch ball joint
assemblies.
c.
Tighten using two 9/16-inch open-end
wrenches.
NOTE
For more information on cotter pins, go to General Maintenance Instructions (page
2-424).
35. Throttle lever
Modulator cable (6),
a.
Put on modulator cable and flat washer.
(4) and machine
flat washer (7), and
b.
Using 6-inch diagonal-cutting pliers,
bolt (5)
cotter pin (8)
put in cotter pin and bend back legs.
36. Modulator cable
Spring (10)
Put in using 6-inch slip-joint pliers.
(6) and bracket (9)
37. Fuel pump bracket
Spring (12)
Put in using 6-inch slip-joint pliers.
(11) and accelerator
control rod (1)
2-560
