TM 5-3805-254-20-1
HAND THROTTLE CONTROL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
20.
Hand throttle
Clamp (2)
Put on.
cable (1)
21.
Hand throttle
Clamp (2), screw
Screw on and tighten using 7/16-inch, 1/2-
bar (3)
(4), new lockwasher
inch drive socket, ratchet handle, an d
(5), and nut (6)
7/16-inch box-end wrench.
22.
Hand throttle
Swivel (7)
Put on.
cable (1)
NOTE
For more information on cotter pins, go to General Maintenance Instructions (page 2-424).
23.
Lever assembly (8)
Flat washer (9) and
a.
Put on flat washer.
new cotter pin (10)
b.
Put in cotter pin and bend back ends
using 6-inch diagonal-cutting pliers.
24.
Hand throttle
Throttle stop (11)
a.
Put throttle stop on hand throttle cable.
cable (1)
and screw (12)
b.
Tighten screw using 3/16-inch flat-tip
screwdriver.
ADJUSTMENT
25.
Dashboard (13)
Hand throttle
Push in.
handle (14)
26.
Hand throttle
Throttle stop (11)
a.
Using 3/16-inch flat-tip screwdriver,
cable (1)
and screw (12)
loosen screw.
b.
Take off throttle stop.
27.
Lever assembly (8)
Push down.
28.
Throttle stop
a.
Put throttle stop on hand throttle cable.
(11) and screw (12)
Leave a small space between throttle
stop and swivel.
b.
Tighten screw using 3/16-inch flat-tip
screwdriver.
2-588
