TM 5-3805-254-20-1
EXHAUST PIPE FRONT HANGER - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Exhaust system parts become very hot when engine is running. Allow time for parts to cool
before working on exhaust system. Hot exhaust system parts will cause serious burns.
1.
Loop clamp (1)
Two nuts (2)
Using 11/16-inch box-end wrench, un-
and two flat
screw and take off.
washers (3)
2.
Bracket (4) and
Loop clamp (1)
Take off.
exhaust pipe (5)
and saddle (6)
3.
Transmission (7)
Two screws (8),
a.
Using 9/16-inch box-end wrench, un-
two lockwashers
screw and take out.
(9), and bracket (4)
b.
Take off bracket.
c.
Get rid of lockwashers.
INSPECTION
NOTE
Replace all damaged or defective parts.
For more information on how to inspect parts, go to General Maintenance Instructions
(page 2-424).
4.
Bracket (4)
Look for cracks, breaks, bends, or over-
sized holes.
5.
All threaded parts
Look for damaged threads or rounded
heads.
INSTALLATION
6.
Transmission (7)
Bracket (4), two
a.
Put in position.
screws (8), and two
b.
Screw in and tighten using 9/16-inch
new lockwashers (9)
box-end wrench.
7.
Bracket (4) and
Loop clamp (1)
Put around exhaust pipe and through
exhaust pipe (5)
and saddle (6)
bracket.
8.
Loop clamp (1)
Two nuts (2) and
Screw on and tighten using 11/16-inch box-¾
two flat washers (3)
end wrench.
2-620
