TM 5-3805-254-20-1
EXHAUST DIVERTER BRACKET SUPPORTS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
11.
Rear of cab (1)
Lower support (2),
a.
Put lower support into position.
four screws (3),
b.
Screw in and tighten using 9/16-inch
and four new lock-
box-end wrench.
washers (4)
12.
Lower support (2)
Upper insulator (5),
a.
Put upper insulator into position.
spacer (6), and
b.
Push spacer up through upper insulator.
lower insulator (7)
c.
Put lower insulator on spacer.
13.
Upper support (8)
Put into position.
14.
Upper support (8)
Screw (9), flat
a.
Push screws down through upper
washer (10), new
support.
lockwasher (11),
b.
Put on flat washer, new lockwasher, and
and nut (12)
nut.
NOTE
Aline open holes on upper and lower supports.
15.
Screw (9) and
Tighten using 5/8-inch and 11/16-inch
nut (12)
box-end wrenches.
16.
Muffler (13)
Loop clamp (14)
Put on.
and saddle (15)
17.
Two nuts (16) and
Screw on and tighten using 9/16-inch box-
flat washers (17)
end wrench.
2-618
