TM 5-3805-254-20-1
EXHAUST DIVERTER BRACKET - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION
8.
Upper support (1)
Bracket (3)
Put between upper and lower supports.
and lower support (2)
9.
Two upper insulators
a.
Put upper insulators in position.
(4), two spacers
b.
Push spacers up through upper
(5), two lower insulators.
insulators (6)
c.
Put lower insulators on spacers.
10.
Two screws (7), two
a.
Push screws down through upper
flat washers (8), two
support (1).
new lockwashers (9),
b.
Put on flat washers, new lockwashers,
and two nuts (10)
and nuts.
Hand tighten.
11.
Exhaust
Bracket (3)
Aline holes.
diverter (11)
12.
Bracket (3)
Two screws (12) and
Screw in and tighten using two 3/4-inch
two nuts (13)
box-end wrenches.
13.
Upper support (1)
Two screws (7) and
Tighten using 5/8-inch, 1/2-inch drive
two nuts (10)
socket, 6-inch extension and ratchet han-
dle, and 11/16-inch box-end wrench.
14.
Exhaust
Four springs (14),
a.
Put springs on studs.
diverter (11)
four studs (15), and
b.
Put exhaust shield plate in position.
exhaust shield
plate (16)
15.
Exhaust shield plate
a.
Push exhaust shield plate down.
(16) and four new
b.
Screw on locknuts and tighten using
locknuts (17)
3/4-inch box-end wrench, until springs
begin to compress, then tighten one ad-
ditional turn.
2-614
