TM 5-3805-254-20-1
EXHAUST DIVERTER BRACKET - CONTINUED
INITIAL SETUP:
Tools
Personnel Required
Extension, 6-inch, 1/2-inch drive
One
Handle, ratchet, 1/2-inch drive
Socket, 5/8-inch, 1/2-inch drive
Equipment Condition
Wrench, box-end, 11/16-inch
Wrench, box-end, 3/4-inch (two
Dump body raised and secured
required)
(page 2-424).
Materials/Parts
Lockwasher (two required)
Locknut (four required)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Exhaust system parts become very hot when engine is running. Allow time for parts to
cool before working on exhaust system. Hot exhaust system parts will cause serious
burns.
1.
Exhaust diverter (1)
Four locknuts (2),
a.
Using 3/4-inch box-end wrench, un-
exhaust shield plate
screw and take off.
(3), and four
Get rid of locknuts.
springs (4)
b.
Lift off exhaust shield plate and springs.
2.
Two screws (5) and
Using two 3/4-inch box-end wrenches, un-
two nuts (6)
screw and take off.
3.
Upper support (7)
Two screws (9), two
Using 5/8-inch, 1/2-inch drive socket,
and lower
flat washers (10),
6-inch extension and ratchet handle, and
support (8)
two lockwashers
11116-inch box-end wrench, unscrew and
(11), and two
take out.
nuts (12)
Get rid of lockwashers.
4.
Two lower insulators
a.
Take off lower insulators.
(13), two spacers
b. Pull spacers down and out.
(14), bracket (15),
c. Take off bracket and upper insulators.
and two upper
insulators (16)
2-612
