TM 5-3805-254-20-1
RADIATOR INLET HOSE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
2.
Hose (1)
Two clamps (2)
Using 1/4-inch flat-tip screwdriver,
loosen.
3.
Thermostat housng
Hose (1) and two
Take off.
(3) and elbow (4)
clamps (2)
4.
Inlet (5) and
Hose (6) and two
Take off.
elbow (4)
clamps (7)
5.
Radiator (8)
Two screws (9), two
a.
Using 9/16-inch box-end wrench, un-
flat washers (10),
screw and take out.
two lockwashers
b.
Take off inlet.
(11), inlet (5),
c.
Get rid of lockwashers.
and gasket (12)
d.
Using gasket scraper, scrape off all old
gasket material.
e.
Get rid of gasket.
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-424).
6.
All rubber parts
a.
Clean with solution of liquid detergent
and water.
b.
Rinse in clean water.
c.
Using clean, dry rags, wipe dry.
WARNING
Dry-cleaning solvent P-D-680 is toxic and flammable. Wear protective safety goggles and gloves
and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes and do not
breathe vapors. Do not use near open flame or excessive heat. The flashpoint for type #1 dry-
cleaning solvent is 100°F (38°C) and for type #2 is 138°F (59°C). If you become dizzy while using
cleaning solvent, get fresh air immediately, and get medical aid. If contact with eyes is made,
flush your eyes with water and get medical aid immediately.
7.
All metal parts
a.
Clean with dry-cleaning solvent.
b.
Using clean, dry rags, wipe dry.
2-644
