TM 5-3805-254-20-2
AIR DRYER - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY - CONTINUED
18.
Air dryer (1)
Two plugs (2)
Using 7/8-inch box-end wrench, unscrew
and take out.
19.
90-degree elbow (3)
Using 3/4-inch open-end wrench, unscrew
and take out.
20.
Check valve (4)
90-degree elbow (5)
Using 1 1/4-inch and 13/16-inch open-end
wrenches, unscrew and take out.
21.
Air dryer (1)
Check valve (4)
Using 1 1/4-inch open-end wrench, un-
screw and take out.
22.
90-degree elbow (6)
Pressure relief
Using 3/4-inch open-end wrench, unscrew
valve (7)
and take out.
23.
Air dryer (1)
90-degree elbow (6)
Using 13/16-inch open-end wrench, un-
screw and take out.
24.
Head assembly (8)
45-degree elbow (9)
Using 5/8-inch open-end wrench, unscrew
and take out.
CLEANING
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective safety goggles and gloves and use
only in a well-ventilated area. Avoid contact with skin, eyes, and clothes and do not breathe vapors. Do
not use near open flame or excessive heat. The flashpoint for type #1 drycleaning solvent is 100°F (38°C)
and for type #2 is 138°F (59°C). If you become dizzy while using cleaning solvent, get fresh air
immediately, and get medical aid. If contact with eyes is made, flush your eyes with water and get medical
aid immediately.
Safety goggles must be worn when using wire brush. Flying rust or metal particles could cause eye injury.
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-424).
2-1006
