TM 5-3805-254-20-2
AIR DRYER
This task covers:
a.
Removal (page 2-1002)
d.
Inspection/Replacement (page 2-1008)
b.
Disassembly (page 2-1004)
e.
Assembly (page 2-1009)
c.
Cleaning (page 2-1006)
f.
Installation (page 2-1012)
INITIAL SETUP:
Tools
Materials/Parts
Brush, wire
Lockwasher, clamp to bracket (four required)
Extension, 3-inch, 1/2-inch drive
Lockwasher, cap screw (two required)
Gloves, safety
Rags, wiping (item 15, appendix C)
Goggles, safety
Solvent, drycleaning (item 19, appendix C)
Handle, ratchet, 1/2-inch drive
Tags, marker (item 21, appendix C)
Punch, pin, 1/4-inch
Tape, antiseizing (item 22, appendix C)
Socket, 3/4-inch, 1/2-inch drive
Wrench, box-end, 1/2-inch (two
Personnel Required
required)
Wrench, box-end, 9/16-inch (two
Two
required)
Wrench, box-end, 3/4-inch
References
Wrench, box-end, 7/8-inch
Wrench, open-end, 3/8-inch
TM 43-0139 (Painting Instructions for Army
Wrench, open-end, 5/8-inch
Materiel)-
Wrench, open-end, 3/4-inch
Wrench, open-end, 13/16-inch
Wrench, open-end, 15/16-inch
Wrench, open-end, 1-inch
Wrench, open-end, 11/4-inch
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Drain air from airbrake system before removing lines or fittings to avoid injury to personnel from
compressed air.
1.
Wet air
Automatic drain
Using 1/4-inch pin punch, push in on
reservoir (1)
valve (2)
manual drain pin (3) and allow compressed
air to drain.
Change 1 2-1002
