TM 5-3805-254-20-2
BRAKE PEDAL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1.
Brake pin (1)
Cotter pin (2)
a.
Using 6-inch long-nose pliers, bend
back ends and pull out.
b.
Get rid of.
2.
Brake pedal (3)
Brake pin (1)
Using 6-inch long-nose pliers, pull out.
3.
Brake pedal (3)
Take off.
DISASSEMBLY
4.
Roller pin (4)
Cotter pin (5)
a.
Using 6-inch long-nose pliers, bend
back ends and pull out.
b.
Get rid of.
5.
Brake pedal (3)
Roller pin (4)
Using 6-inch long-nose pliers, pull out.
6.
Roller (6)
Take out.
CLEANING
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective safety goggles and gloves and use
only in a well-ventilated area. Avoid contact with skin, eyes, and clothes and do not breathe vapors. Do
not use near open flame or excessive heat. The flashpoint for type #1 drycleaning solvent is 100°F (38°C)
and for type #2 is 138°F (59°C). If you become dizzy while using cleaning solvent, get fresh air
immediately, and get medical aid. If contact with eyes is made, flush your eyes with water and get medical
aid immediately.
Safety goggles must be worn when using wire brush. Flying rust or metal particles could cause eye injury.
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-424).
7.
Brake pedal (3)
Clean using drycleaning solvent and clean-
ing brush.
8.
Roller (6)
a.
Clean rust using wire brush.
b.
Wipe clean using drycleaning solvent
and wiping rag.
2-1022
