TM 5-3805-254-20-2
AIR COMPRESSOR GOVERNOR TO WET AIR RESERVOIR LINES AND FITTINGS
This task covers:
a.
Removal (page 2-1046)
c.
Inspection/Replacement (page 2-1049)
b.
Cleaning (page 2-1048)
d.
Installation (page 2-1050)
INITIAL SETUP:
Tools
Materials/Parts - Continued
Gloves, safety
Tags, marker (item 21, appendix C)
Goggles, safety
Tape, antiseizing (item 22, appendix C)
Wrench, box-end, 7/16-inch
Wrench, open-end, 7/16-inch
Personnel Required
Wrench, open-end, 9116-inch
Wrench, open-end, 5/8-inch
One
Wrench, open-end, 11/16-inch
Equipment Condition
Materials/Parts
Airbrake system drained (page 2-1034).
Lockwasher, clamp screw, front
Left side hood panel opened (page 2-424).
Rags, wiping (item 15, appendix C)
Solvent, drycleaning (item 19,
appendix C)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Safety goggles must be worn when working under truck to prevent eye injury.
NOTE
Air line is in three sections. Tag sections from front to rear of truck as section 1, section 2, and
section 3.
For more information on how to tag parts, go to General Maintenance Instructions (page 2-424).
1.
Air compressor
Air line (2)
Tag.
governor (1)
2.
Air line (2)
Line nut (3) and
Using 5/8-inch open-end wrench, unscrew
adapter (3.1)
and take off.
Change 1 2-1046
