TM 5-3805-254-20-2
REAR REAR QUICK RELEASE VALVE
This task covers:
a.
Removal (page 2-1130.1) b.
Installation (page 2-1130.2)
INITIAL SETUP
Equipment Conditions
Tools/Test Equipment
Parking and service airbrake hoses disconnected
Goggles, safety
as required (page 2-1131, 2-1136, 2-1140.3,
Wrench, box-end, 7/16-inch
2-1157).
Wrench, open-end, 7/16-inch
Materials/Parts
Personnel Required
Lockwasher, quick release valve (two required)
One
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Safety goggles must be worn when working under truck to prevent eye injury.
NOTE
Steps 1 and 2 are typical to remove only one or both quick release valves.
1.
Rear rear quick
Two nuts (2),
a.
Using 7/16-Inch open-end wrench and 7/16-inch
release valve (1)
lockwashers (3),
box-end wrench, unscrew, and take off.
and screws (4)
b.
Get rid of lockwashers.
TA702163
Change 1 2-1130.1
