TM 5-3805-254-20-2
FRONT HUB AND BREAKDRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
INITIAL SETUP - CONTINUED
Personnel Required
References
Two
LO 5-3805-254-12 (Lubrication order)
Equipment Condition
Front wheels removed (page 2-1168)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
Steps given are typical for right and left front hubs.
1
Front hub (1)
Turn and check for drag caused by binding
brakes.
If drag is felt, perform steps 2, 3,
and 4.
If no drag is felt, go to step 5.
NOTE
Both front and rear brake adjusters must be taken out of adjustment.
Steps given are typical for front and rear brake adjusters.
2
Dust shield (2)
Cover (3)
Using 3/8-inch flat-tip screwdriver, pry
out.
3
Adjuster slot (4)
Brake adjuster (5)
Using brake adjusting tool, loosen enough
to allow front hub to move freely.
4
Cover (3)
Push into place.
5
Grease cap (6)
Plug (7)
a
Turn front hub to position plug at bottom.
b
Place drain pan underneath.
c
Using 5/16-inch hex wrench, unscrew
and take out.
d
Allow oil to drain.
e
Screw in hand tight.
f
Get rid of drained oil (page 2-424).
6
Three screws (8) and
a
Using 7116-inch box-end wrench, un-
three lockwashers (9)
screw and take out.
b
Get rid of lockwashers.
2-1176
