TM 5-3805-254-20-2
REAR HUB AND BRAKEDRUM ASSEMBLY AND WHEEL BEARINGS
This task covers:
a
Removal (page 2-1188)
d
Inspection/Replacement (page 2-1192)
b
Disassembly (page 2-1191)
e
Assembly (page 2-1198)
c
Cleaning (page 2-1192)
f
Installation (page 2-1198)
INITIAL SETUP
Tools
Materials/Parts
Bar, pinch, 26-inch
Cup, bearing, inner (one required)
Blocks, wood, 4 x 4 x 18-inch
Cup, bearing, outer (one required)
(22 x 22 x 46 cm) (five required)
Gasket, flange, axle (one required)
Brush, cleaning
Gasket, seal, outer (one required)
Gloves, safety
Grease, GAA (item 10, appendix C)
Goggles, safety
Nuts, self-locking (eight required)
Hammer, ball-peen, 1-pound
Rags, wiping (item 15, appendix C)
Hammer, cross-peen, 3-pound
Seal, inner (one required)
Hammer, cross-peen, 12-pound
Seal, outer (one required)
Handle, hinged, 3/4-inch drive
Solvent, drycleaning (item 19, appendix C)
Handle, ratchet, 1/2-inch drive
Pan, drain, 1-gallon
Personnel Required
Puller
Punch, driftpin, brass
Three
Screwdriver, flat-tip, 1/2-inch
Socket, deep, 3/4-inch, 1/2-inch
Equipment Condition
drive
Socket, 15/16-inch, 1/2-inch drive
Rear wheel removed (page 2-1171).
Socket, 4-inch, 3/4-inch drive
Wrench, torque, 0 to 600 ft lb
References
(0 to 814 N.m), 3/4-inch drive
LO 5-3805-254-12 (Lubrication Order)
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
Steps given are typical for right and left front rear and rear rear hubs.
2-1188
