TM 5-3805-254-20-2
REAR HUB AND BRAKEDRUM ASSEMBLY AND WHEEL BEARINGS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
5
Rear hub (1)
Axle (2) and axle
a
Pull out axle.
flange gasket (3)
b
Take off gasket.
c
Get rid of gasket.
6
Outer seal (4)
a
Take off.
and outer seal
b
Get rid of outer seal and outer seal
gasket (5)
gasket.
7
Spindle (6)
Locknut (7)
Using 4-inch, 3/4-inch drive socket and
hinged handle, unscrew and take off.
8
Adjusting nut
Pull off.
lock (8)
9
Adjusting nut (9)
Using 4-inch, 3/4-inch drive socket and
hinged handle, unscrew and take off.
WARNING
Due to excessive weight, care must be taken to prevent rear hub and brakedrum assembly from falling Do
not pull out too far on spindle Serious injury to personnel could result.
NOTE
Assistance will be needed to perform steps 10 and 11.
10
Rear hub (1) and
a
Pull rear hub out enough to free outer
outer bearing (10)
bearing.
b
Push rear hub back in.
c
Take off outer bearing.
WARNING
Due to excessive weight, assistance will be needed to lift hub and brakedrum assembly. Failure to observe
this precaution could cause serious injury to personnel.
2-1190
