TM 5-3805-254-20-2
FILLING STEERING SYSTEM - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
2.
Reservoir (1)
Filler neck (2)
Fill with lubricating oil to 4 inches (10.16
cm) below top of filler neck using 6-inch
machinist scale.
3.
Cap (3)
Put on.
CAUTION
Failure to perform the following steps could cause serious damage to equipment.
4.
Dump truck (4)
Engine (5)
a.
Start (TM 5-3805-254-10).
b.
Let idle.
5.
Steering wheel (6)
Slowly turn to full left and to full right three
times.
6.
Engine (5)
Shut down (TM 5-3805-254-10).
7.
Reservoir (1)
Cap (3)
a.
Pull up and out.
b.
Using wiping rag, wipe clean.
c.
Put in completely.
d.
Pull up and out.
If oil is up to F (full) mark go to step 8.
If oil is below F (full) mark repeat
steps 2 thru 7.
8.
Cap (3)
Put on.
9.
Dump truck (4)
Engine (5)
a.
Start (TM 5-3805-254-10).
b.
Run at 900 rpm.
10.
Steering wheel (6)
Slowly turn to full left and to full right
for three minutes.
11.
Engine (5)
Shut down (TM 53805-254-10).
12.
Engine (5)
Reservoir (1)
Repeat steps 1, 2, and 3.
NOTE
Steps 13, 14, and 15 are typical for both left and right steering arms.
2-1244