TM 5-3805-254-20-2
FILLING STEERING SYSTEM - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
FILLING - CONTINUED
17
Dump truck (1)
Engine (2)
a.
Start (Refer to TM 5-3805-254-10).
b.
Let idle.
WARNING
Stand clear of steering arms while performing step 18. Failure to observe this precaution
could cause serious injury to personnel.
CAUTION
Do not move steering arms by hand. Air could be pulled back into system.
NOTE
Assistance will be needed to perform steps 18 thru 22.
Steps 18 thru 22 are typical for both left and right steering arms.
18.
Steering wheel (3)
a.
Have assistant turn steering wheel to full
left and hold until right steering arm
moves to stop.
b.
Turn to full right and hold until right
steering arm moves to stop.
c.
Repeat a and b three times.
d.
Turn to aline left steering arm with link
end.
19.
Engine (2)
Shut down (TM 5-3805-254-10).
20.
Left steering
Link end (5)
Put in.
arm (4)
21.
Link end (5)
Nut (6)
Screw on and tighten using 1 5/16-inch
open-end wrench.
Aline hole in link end with slot In nut.
22.
Link end (5)
New cotter pin (7)
Put in and bend ends back using 8-inch
and nut (6)
roundnose pliers (page 2-424).
23.
Dump truck (1)
Engine (2)
a.
Start (TM 5-3805-254-10).
b.
Let idle.
24.
Dump truck (1)
Steering wheel (3)
Repeat step 18.
and right steering
arm (8)
2-1246
