TM 5-3805-254-34
5-4.
STARTER MOTOR END PLAY ADJUSTMENT (Cont).
NOTE
Perform steps 8 through 11 only if 0.040-inch or 0.030-Inch feeler gage fits between clutch motor
drive gear and starter housing collar.
8.
Remove plug (16) and gasket (17) from solenoid switch (6). Discard gasket.
9.
Set switch (18) to ON until solenoid switch (6) pushes clutch motor drive gear (21) against starter housing collar
(15).
10.
Position 0.035-inch feeler gage between clutch motor drive gear (21) and starter housing collar (15) and turn lever
nut (20) to point where feeler gage just slips out. Set switch (18) to OFF and turn off power supply. If end play will
not adjust, repair starter motor (see paragraph 5-3).
11.
Install new gasket (17) and plug (16) on solenoid switch (6).
12.
Remove cables (1, 5, and 9) from power supply (4) and motor (19).
13.
Perform starter motor test (see paragraph 5-2).
TA703727
5-34