TM 5-3805-254-34
6-15.
OIL PUMP, FRONT SUPPORT, AND CONVERTER HOUSING REPLACEMENT.
This Task Covers:
a.
Removal
c.
Installation
b.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
•
Torque converter removed (see paragraph 6-11)
•
Grease (Item 10, Appendix B)
•
Dry cleaning solvent (Item 23, Appendix B)
Tools/Test Equipment:
•
One gasket
•
General mechanic's tool kit
•
Two seal rings
•
Field automotive shop set
•
Fourteen lockwashers
•
Two guide screws, pitot tube
General Safety Instructions:
•
Two lifting eyes and nuts
•
Dry cleaning solvent is flammable and must not be
Personnel Required: Two
used near open flame. Use only In a well-ventilated
area.
a.
REMOVAL
NOTE
Removal of screws and washers will free pitot tube under converter of housing.
1.
With transmission in a vertical position, remove two
small screws (2) and washers (1) from inside
converter housing (5).
2.
Remove seven screws (3) and lockwashers (4).
TA703807
6-86
