TM 5-3805-254-34
6-27. TRANSMISSION HOUSING REPAIR (Con’t)
4.
Turn transmission housing (1) over and remove
retainer pin (5) and locknut (6) from manual
selector shaft (9). Discard locknut.
5.
Remove manual selector shaft (9) and Inside
detent lever (7).
6.
Using manual shaft oil seal installer, remove
selector shaft oil seal (8). Discard selector shaft
oil seal.
b.
CLEANING AND INSPECTION I
WARNING
Dry cleaning solvent, PD680, Is toxic and flammable. Always wear protective goggles and gloves,
and use only In a well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO NOT
breathe vapors. DO NOT use near open flame or excessive heat. The solvent’s flash point Is
100°F1380F (380C590C). If you become dizzy while using cleaning solvent, Immediately get
fresh air and medical help. If solvent contacts eyes, Immediately wash your eyes and get medical
aid.
1. Clean metal parts with dry cleaning solvent.
2. Inspect metal parts for cracks, breaks, wear, and other damage. Replace if damaged.
3. Inspect plug for damage. Replace if damaged.
TA703836
6-118
