TM 5-3805-254-34
6-29. FRONT SUPPORT REPAIR.
This Task Covers:
a.
Disassembly
b.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
•
Converter housing removed (see paragraph 6-I5).
Tools/Test Equipment:
•
General mechanic's tool kit
•
Field automotive shop set
•
Bearing installer
•
Handle
•
Spring compressor
c.
Assembly
Materials/Parts:
•
Hydraulic fluid (Item 7, Appendix B)
•
Dry cleaning solvent (Item 23, Appendix B)
•
Two preformed packings
General Safety Instructions:
•
Dry cleaning solvent is flammable and must not
be used near open flame. Use only in a well-
ventilated area.
a.
DISASSEMBLY
NOTE
Keep parts of each of three valves separate to avoid mixing parts.
1. Using spring compressor, press Inward on
washer (6) and remove snapring (7).
2. Remove spring compressor, washer (6), valve
stop (5), spring (4), and main pressure regulator
(3) from front support (1).
3. Remove preformed packing (2) from main
pressure regulator (3). Discard preformed
packing.
6-122
